Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

OFF2000: UserName and CompanyName Fields Not Set to Blanks


View products that this article applies to.

This article was previously published under Q226530

↑ Back to the top


Symptoms

When installing Office, the UserName and CompanyName fields are filled in, even if you use a command line switch or transform(.mst) file to suppress these fields.

↑ Back to the top


Cause

This will occur when you attempt to set the UserName and CompanyName properties to blank, either by using a command line, or by specifiying the settings in the setup.ini file. For example, if you use the following command line to start Office Setup

setup.exe USERNAME="" COMPANYNAME=""
					
the UserName and CompanyName fields are still populated.

↑ Back to the top


Resolution

To set the UserName and CompanyName properties to blank, use the NoCompanyName and NoUserName properties. These properties can be used either on the commmand line, in the setup.ini file, or in a transform (.mst) file. When using these properties, they must be set to one (1). For example, if you use the following command line to start Office Setup:
setup.exe NOCOMPANYNAME=1 NOUSERNAME=1
					
the UserName and CompanyName fields will be suppressed.

↑ Back to the top


References

For additional information on how to customize Office Setup, check the Microsoft Office 2000 Resource Kit documentation, or check out the Office 2000 Resource kit online at:

↑ Back to the top


Keywords: kbbug, kbfix, KB226530

↑ Back to the top

Article Info
Article ID : 226530
Revision : 4
Created on : 1/24/2007
Published on : 1/24/2007
Exists online : False
Views : 376