Microsoft KB Archive Search

Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

  1. Home
  2. How to change the physical (MAC) address of the Network Connector on a server that is running Intelligent Application Gateway (IAG)

How to change the physical (MAC) address of the Network Connector on a server that is running Intelligent Application Gateway (IAG)

View products that this article applies to.

INTRODUCTION

This article describes how to change the physical (MAC) address of the Network Connector on a server that is running Intelligent Application Gateway (IAG).

↑ Back to the top

More Information

To change the physical address of the Network Connector, follow these steps:
  1. On the server that is running IAG, click Start, point to Control Panel, and then click System.
  2. On the Hardware tab, click Device Manager.
  3. Expand Network adapters, right-click Whale Network Connector, and then click Properties.
  4. On the Advanced tab, click Mac Seed in the Property list.
  5. In the Value spin box, type the value that you want, and then click OK.

    Note This value can range from 0 to 255. By default, the Mac Seed value is set to decimal 71 (0x47). This value corresponds to a physical address of 00-FF-08-01-19-47.
  6. Close Device Manager.
  7. To verify the physical address that you configured, open a command prompt, type the following command, and then press ENTER:
    ipconfig /all

↑ Back to the top

Keywords: kbhowto, kbexpertiseinter, kbinfo, kb

↑ Back to the top

Article Info
Article ID : 955103
Revision : 1
Created on : 1/7/2017
Published on : 6/22/2014
Exists online : False
Views : 156