Microsoft KB Archive Search

Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

  1. Home
  2. The subform appears to be blank after you close a Filter by Form view without applying the filter in Access 2007

The subform appears to be blank after you close a Filter by Form view without applying the filter in Access 2007

View products that this article applies to.

Symptoms

When you close a form in Microsoft Office Access 2007, the subform appears to be blank.

This problem occurs if the following conditions are true:
  • You apply the Filter by Form view to a form that contains a subform.
  • You select a filter value for a control in the subform, and then you close the Filter by Form view without applying the filter.

↑ Back to the top

Cause

This problem occurs because the filter is applied to the form when the Filter by Form view is closed. This occurs even when you do not apply the filter. When this occurs, the Status bar does not indicate that the filter has been applied to the form.

↑ Back to the top

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

↑ Back to the top

Keywords: KB926956, kbexpertiseinter, kbprb, kbbug, kbtshoot

↑ Back to the top

Article Info
Article ID : 926956
Revision : 2
Created on : 10/15/2007
Published on : 10/15/2007
Exists online : False
Views : 303