Bank Transaction Entry Using Multicurrency

Question:

I recently purchased multicurrency. I went through and entered the keys and also ran check links on all the multicurrency tables and checkbook master. I see that it populated the correct functional currency, but when I go to the bank transaction entry window the transaction entry only brings up the functional currency and it is dimmed so I can’t make changes to it. Why is this happening only for transactions and not receipts?

Answer:

If the checkbook is setup with functional currency, than you can enter transactions and receipts with any currency.

If the checkbook is an alternate currency, then here is how the break down works for bank transaction entry:

Receipts -both functional currency and currency assigned to the checkbook

can be used



Transactions -only the currency that is assigned to the checkbook can be

used and the currency id will be dimmed



Increase/Decrease adjustments -only the currency assigned to the

checkbook can be used and the currency id will be dimmed



This article was TechKnowledge Document ID: 24261

MICROSOFT AND/OR ITS SUPPLIERS MAKE NO REPRESENTATIONS OR WARRANTIES ABOUT THE SUITABILITY, THE RELIABILITY OR THE ACCURACY OF THE INFORMATION THAT IS CONTAINED IN THE DOCUMENTS AND THE RELATED GRAPHICS PUBLISHED ON THIS WEB SITE (THE “MATERIALS”) FOR ANY PURPOSE. 

THE MATERIALS MAY INCLUDE TECHNICAL INACCURACIES OR TYPOGRAPHICAL ERRORS AND MAY BE REVISED AT ANY TIME WITHOUT NOTICE. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, MICROSOFT AND/OR ITS SUPPLIERS DISCLAIM AND EXCLUDE ALL REPRESENTATIONS, WARRANTIES, AND CONDITIONS WHETHER EXPRESS, IMPLIED OR STATUTORY, INCLUDING BUT NOT LIMITED TO REPRESENTATIONS, WARRANTIES, OR CONDITIONS OF TITLE, NON-INFRINGEMENT, SATISFACTORY CONDITION OR QUALITY, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE MATERIALS.