Microsoft KB Archive Search

Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

  1. Home
  2. How to use System files to create a boot disk to guard against being unable to start Windows XP

How to use System files to create a boot disk to guard against being unable to start Windows XP

To continue receiving security updates for Windows, make sure you're running Windows XP with Service Pack 3 (SP3). For more information, refer to this Microsoft web page: Support is ending for some versions of Windows

↑ Back to the top

For a Microsoft Windows 2000 version of this article, see 101668 .

↑ Back to the top

INTRODUCTION

If your computer uses an Intel x86-based processor, and the startup record for the active partition or files that you must have to start Windows become corrupted, you may not be able to start your computer. This article describes how to create a startup disk. With a startup disk, you can start your computer if the startup record becomes corrupted.

↑ Back to the top

More Information

Create a Windows startup disk when you first install Windows on the computer. This disk is different from an MS-DOS startup disk. Unlike MS-DOS, the whole Windows operating system cannot fit on one floppy disk. A Windows startup disk contains only the files that you must have to start the operating system with the remainder of the Windows system files installed on the hard disk drive. To create the startup disk, follow these steps:
  1. Insert a blank floppy disk in drive A, and then format the disk by using Windows XP.
  2. From the root folder of the system partition of your hard disk drive (for example, C:\-), copy the following files to the floppy disk:
    Boot.ini
    NTLDR
    Ntdetect.com
    You may have to remove the hidden, system, and read-only attributes from the files.
  3. Restore the hidden, system, and read-only attributes to the files on your hard disk if you removed these attributes.
  4. If the Bootsect.dos file or the Ntbootdd.sys file resides in the system partition, repeat steps 2 through 4 to copy these files to the boot disk.
If you format a floppy disk in Windows XP, the startup record points to the NTLDR file. When NTLDR runs, it loads the available operating system selections from the Boot.ini file. If you select Windows, NTLDR runs Ntdetect.com, and then passes control to Osloader.exe. If you select
MS-DOS or OS/2, NTLDR loads Bootsect.dos.

↑ Back to the top

Keywords: kbacwsurvey, kbhowto, kbenv, kbinfo, kbsetup, kbusage, kb

↑ Back to the top

Article Info
Article ID : 314079
Revision : 2
Created on : 12/13/2018
Published on : 12/13/2018
Exists online : False
Views : 258