Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

The Workstation service does not start during a repair-mode upgrade


View products that this article applies to.

This article was previously published under Q313912

↑ Back to the top


Symptoms

If you upgrade a domain member computer in Repair mode, Setup continues in GUI mode after the computer restarts, but the networking components are not installed correctly. You receive an error message that is similar to:
Domain cannot be connected to or joined because the workstation service is not started.

↑ Back to the top


Cause

You receive the error message because the Workstation services does not start.

↑ Back to the top


Resolution

Continue the installation, and then join the computer to the domain again after the Repair-mode upgrade is completed.

↑ Back to the top


Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.

↑ Back to the top


Keywords: kberrmsg, kbsetup, kbprb, KB313912

↑ Back to the top

Article Info
Article ID : 313912
Revision : 8
Created on : 2/27/2007
Published on : 2/27/2007
Exists online : False
Views : 562