Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

After resuming from s3/s4 in windows 10, mobile broadband devices may not work properly


Symptoms

 

After resuming from s3/s4 in windows 10, you may still see the MBIM interface in UI or by running the command “netsh mbn show interfaces”. However, you cannot use the MBIM device anymore. For example, if you try to click “connect” to establish a new connection in the cellular UI of the control panel, you will see it just keeps connecting

↑ Back to the top


Cause

 

The problem could happen if the following conditions are true.

 1.    “Allow this device to wake the computer” option of the MBIM device is enabled

 2.    The USB port that the MBIM device attached to will be powered off in s3/s4, and the power of the USB port will be turned on after resuming from s3/s4. This is done by the hardware directly.

 When the “Allow this device to wake the computer” power option is enabled, windows will maintain the original MBIM session so MBIM_OPEN command will not be issued after resuming. However, since the USB port loses power, the MBIM device would not respond to other command until it receives the MBIM_OPEN command to re-initialize. Hence, the device may not work properly after resuming.

↑ Back to the top


Resolution

 

To work around this issue:

1.  Open Device Manager. 

2.  Right-click on the mobile broadband device, and select Properties. 

3.  Select the Power Management  tab. 

4.  Clear/Uncheck the " Allow this device to wake the computer " option. 

5.  Click OK. 

6.  Close Device Manager. 

↑ Back to the top


Keywords: vkball, kb

↑ Back to the top

Article Info
Article ID : 3098951
Revision : 1
Created on : 1/8/2017
Published on : 9/25/2015
Exists online : False
Views : 68