Microsoft KB Archive Search

Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

  1. Home
  2. XCCC: How to Enable Protocol Logging for POP3 and IMAP4 in Exchange 2000

XCCC: How to Enable Protocol Logging for POP3 and IMAP4 in Exchange 2000

View products that this article applies to.

This article was previously published under Q296900

↑ Back to the top

Summary

This article describes how to configure logging for the Post Office Protocol 3 (POP3) and Internet Message Access Protocol 4 (IMAP4) protocols in Exchange 2000. After you configure logging, the results are reported in the Application log in Windows 2000 Event Viewer.

↑ Back to the top

More information

To enable logging of POP3 and IMAP4 protocols in Exchange 2000:
  1. Click Start, point to Programs, point to Microsoft Exchange, and then click System Manager.
  2. Click to expand the Servers object, right-click your Exchange 2000 computer, and then click Properties.
  3. Click the Diagnostic Logging tab, and then click either IMAP4Svc or POP3Svc in the Services section.
  4. In the Categories section, click the category that you want to track, and then set the logging level (for example, Minimum, Medium, or Maximum) in the Logging Level section.
  5. Click OK.

↑ Back to the top

Keywords: KB296900, kbinfo

↑ Back to the top

Article Info
Article ID : 296900
Revision : 5
Created on : 2/27/2007
Published on : 2/27/2007
Exists online : False
Views : 263