Microsoft KB Archive Search

Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

  1. Home
  2. IP addresses are unusable after the DHCP migration to Windows Server 2012 R2 or Windows Server 2012

IP addresses are unusable after the DHCP migration to Windows Server 2012 R2 or Windows Server 2012

View products that this article applies to.

Symptoms

Assume that you perform a migration for your Dynamic Host Configuration Protocol (DHCP) servers to servers that are running Windows Server 2012 R2 or Windows Server 2012. Then, you configure DHCP failover on the servers. After the migration, you notice that several IP addresses in each scope are marked as BAD_ADDRESS in the DHCP server address lease table and become permanently unusable. Specifically, the scope statistics on the primary and secondary server are not synced correctly.

↑ Back to the top

Cause

This issue occurs because DHCP servers lease the IP addresses that are actually owned by some client after the migration. Then, these IP addresses are marked as BAD_ADDRESS.

↑ Back to the top

Resolution

To resolve this issue in Windows Server 2012 R2, install update 2919355.
To resolve this issue in Windows Server 2012, install update rollup 2919393.

For more information about how to obtain update 2919355, click the following article number to go to the article in the Microsoft Knowledge Base:
2919355 Windows RT 8.1, Windows 8.1, and Windows Server 2012 R2 Update April, 2014

For more information about how to obtain update rollup 2919393, click the following article number to go to the article in the Microsoft Knowledge Base:
2919393 Windows RT, Windows 8, and Windows Server 2012 update rollup: February 2014

Note After you apply this update, IP addresses that are marked as BAD_ADDRESS will be removed when clients renew those IP Addresses.

↑ Back to the top

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

↑ Back to the top

More Information

For more information about how to configure DHCP for failover, go to the following Microsoft website:
How to configure DHCP for failover in Windows Server 2012

↑ Back to the top

References

See the terminology Microsoft uses to describe software updates for more information.

↑ Back to the top

Keywords: kbqfe, kbhotfixserver, kbfix, kbsurveynew, kbexpertiseinter, kb

↑ Back to the top

Article Info
Article ID : 2922695
Revision : 1
Created on : 1/7/2017
Published on : 4/8/2014
Exists online : False
Views : 312