Cluster Configuration Does Not Work and You Receive a "Networks Enumerator Was Not Found" Error Message

The analysis portion of the Add Cluster Computers wizard may not work, and you may receive the following error message:

This problem can occur if the Analysis wizard detects that there are multiple network adapters on the same logical network. The Cluster service uses only the first network adapter that it finds on a subnet, and ignores any additional adapters that it discovers on the same subnet.

This problem can occur if you are using IP addresses that are obtained from a Dynamic Host Configuration Protocol (DHCP) server, or if the server is unable to obtain an IP address from a DHCP server and autonet addresses were used for multiple network adapters.

To resolve this problem, use only static IP addresses for both your public and private networks, and verify that the addresses that you are using are on different networks. In addition, verify that you have configured the private network correctly. For additional information about how to verify that you have correctly configured the private network, click the article number below to view the article in the Microsoft Knowledge Base:

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.