Microsoft KB Archive Search

Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

  1. Home
  2. Windows 2000 Server with Incoming Connections Configured Loses TCP/IP Redundancy Features

Windows 2000 Server with Incoming Connections Configured Loses TCP/IP Redundancy Features

View products that this article applies to.

This article was previously published under Q254236

↑ Back to the top

Symptoms

When you configure a Microsoft Windows 2000 Server-based computer to accept incoming calls, you cannot configure the following redundancy features of TCP/IP:
Dead Gateway Detection

Accepting ICMP Redirects from Routers

↑ Back to the top

Cause

This behavior occurs because the Windows 2000 Server operating system enables Routing and Remote Access components when you configure an incoming connection. Routing and Remote Access components on Windows 2000 Server allow only one route to the same destination.

↑ Back to the top

Resolution

To resolve this issue, install the RIP Listener (Silent RIP) component if the network uses Routing Information Protocol (RIP) routing protocols to provide the server with knowledge of redundant network paths. If Microsoft Windows CE synchronization is the reason you need the incoming connection, use ActiveSync 3.0. This version does not use incoming connections and does not exhibit this behavior.

↑ Back to the top

Keywords: KB254236, kbprb

↑ Back to the top

Article Info
Article ID : 254236
Revision : 4
Created on : 3/1/2007
Published on : 3/1/2007
Exists online : False
Views : 381