Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

The DomainController parameter does not work when you use the MoveMailbox.ps1 script to move mailboxes in an Exchange Server 2010 environment


View products that this article applies to.

Symptoms

Consider the following scenario. You move mailboxes by using the MoveMailbox.ps1 script in a Microsoft Exchange Server 2010 environment. You use the DomainController parameter to specify a domain controller that writes the configuration changes. In this scenario, the script ignores the specified domain controller, and selects one available domain controller to write the changes.

↑ Back to the top


Cause

This issue occurs because the MoveMailbox.ps1 script does not pass the DomainController parameter to the New-MoveRequest cmdlet.

↑ Back to the top


Resolution

To resolve this issue, install the following update rollup:
2579150 Description of Update Rollup 4 for Exchange Server 2010 Service Pack 1

↑ Back to the top


Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

↑ Back to the top


More Information

For more information about how to move mailboxes by using the MoveMailbox.ps1 script, visit the following Microsoft website:For more information about the New-MoveRequest cmdlet, visit the following Microsoft website:

↑ Back to the top


Keywords: kbqfe, kbfix, kbsurveynew, kbexpertiseinter, kbhotfixrollup, kb

↑ Back to the top

Article Info
Article ID : 2477273
Revision : 2
Created on : 9/25/2018
Published on : 9/25/2018
Exists online : False
Views : 390