Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

Design-Time Control command not available


View products that this article applies to.

This article was previously published under Q206059
For a Microsoft FrontPage 98 version of this article, see 179063 (http://support.microsoft.com/kb/179063/ ) .
For a Microsoft FrontPage 98 version of this article, see 179063 (http://support.microsoft.com/kb/179063/ ) .

↑ Back to the top


Symptoms

When you point to Advanced on the Insert menu in Microsoft FrontPage 2000, the Design-Time Control command is not available (dimmed).

↑ Back to the top


Cause

You do not have Design-Time Controls (DTC) installed on your computer. Before you can use a DTC with FrontPage 2000, you must first install one or more of them on your computer. After you install at least one DTC, the Design-Time Control command will be available.

↑ Back to the top


More information

Microsoft Visual Interdev installs four Design-Time Controls:
   Data Command Control
   Data Range Footer Control
   Data Range Header Control
   Include Control
				
Any additional Design-Time Controls you install on your computer will be available for use in FrontPage.

For more information about installing additional Design-Time Controls, visit the following Microsoft World Wide Web site: For more information about Microsoft Visual Interdev, visit the following Microsoft World Wide Web site: For more information about ActiveX Controls, visit the following Microsoft World Wide Web site:

↑ Back to the top


Keywords: KB206059, kbprb, kbfix

↑ Back to the top

Article Info
Article ID : 206059
Revision : 4
Created on : 6/27/2007
Published on : 6/27/2007
Exists online : False
Views : 360