Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

How to change Terminal Server's listening port


View products that this article applies to.

Summary

By default Terminal Server and Windows 2000 Terminal Services uses TCP port 3389 for client connections. Microsoft does not recommend that this value be changed. However, if it becomes necessary to change this port, follow these instructions.

↑ Back to the top


More information

Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:
322756 How to back up and restore the registry in Windows

To change the default port for all new connections created on the Terminal Server:
  1. Run Regedt32 and go to this key:
    HKEY_LOCAL_MACHINE\System\CurrentControlSet\Control\Terminal Server\WinStations\RDP-Tcp
    NOTE: The above registry key is one path; it has been wrapped for readability.

  2. Find the "PortNumber" subkey and notice the value of 00000D3D, hex for (3389). Modify the port number in Hex and save the new value.

    To change the port for a specific connection on the Terminal Server:
    • Run Regedt32 and go to this key:
      HKEY_LOCAL_MACHINE\System\CurrentControlSet\Control\Terminal Server\WinStations\connection
      NOTE: The above registry key is one path; it has been wrapped for readability.
  3. Find the "PortNumber" subkey and notice the value of 00000D3D, hex for (3389). Modify the port number in Hex and save the new value.

    NOTE: Because the use of alternate ports has not been fully implemented for Terminal Server 4.0, support will be provided as "reasonable effort" only, and Microsoft may require you to set the port back to 3389, if any problems occur.

To Alter the Port on the Client Side

  1. Open Client Connection Manager.
  2. On the File menu, click New Connection, and then create the new connection. After running the wizard, you should have a new connection listed there.
  3. Making sure that the new connection is highlighted, on the File menu, click Export. Save it as name.cns.
  4. Edit the .cns file using Notepad changing "Server Port=3389" to "Server Port=xxxx" where xxxx is the new port that you specified on Terminal Server.
  5. Now import the file back into Client Connection Manager. You may be prompted to overwrite the current one, if it has the same name. Go ahead and overwrite it. You now have a client that has the correct port settings to match your change Terminal Server settings.
NOTE The Windows 2000 Terminal Server ActiveX client connects only to TCP port 3389. This configuration cannot be changed. The Terminal Server ActiveX client that is available in Microsoft Windows XP and in Microsoft Windows Server 2003 supports the ability to modify the port settings. For more information, click the following article number to view the article in the Microsoft Knowledge Base:
326945 How to change the listening port in the Windows Terminal Server Web client

NOTE: You must restart the Terminal Server before the new listening port becomes active, or recreate the RDP listener via Terminal Services configuration.

↑ Back to the top


Keywords: KB187623, kbinfo

↑ Back to the top

Article Info
Article ID : 187623
Revision : 10
Created on : 2/22/2007
Published on : 2/22/2007
Exists online : False
Views : 164