Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

How to Convert a Drive to FAT32 Using Drive Converter


View products that this article applies to.

Summary

This article describes how to convert a hard disk that uses the File Allocation Table (FAT or FAT16) file system to the FAT32 file system using Drive Converter.


WARNING: After you convert your hard disk to FAT32, you are unable to convert it back to the original FAT system. Also, this procedure does not work if your hard disk has bad sectors.

↑ Back to the top


More Information

To convert a drive to the FAT32 file system, use the following steps.


NOTE: Before you convert to the FAT32 file system, uninstall any utilities or tools that protect or encrypt the Master Boot Record (MBR) or partition table (for example, uninstall Bootlock included with Symantec Norton Your Eyes Only).

Method 1

  1. Click Start, point to Programs, point to Accessories, point to System Tools, click Drive Converter (FAT32), and then click Next.
  2. In the Drives box, click the drive you want to convert to the FAT32 file system.
  3. Click Next, and then click OK.
  4. Click Next, click Next, and then click Next again.
  5. When the conversion is complete, click Finish.

Method 2

At a command prompt, type cvt drive: /cvt32 and then press ENTER, where drive is the drive you want to convert to the FAT32 file system.


For more information about the FAT32 file system, see the following article in the Microsoft Knowledge Base:

154997 Description of the FAT32 File System
NOTE: A drive must be at least 512 megabytes (MB) in size to be converted to the FAT32 file system.

↑ Back to the top


Keywords: kbfaq, kbhowto, kb

↑ Back to the top

Article Info
Article ID : 180134
Revision : 4
Created on : 8/1/2019
Published on : 8/1/2019
Exists online : False
Views : 319