Microsoft KB Archive Search

Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

  1. Home
  2. FIX: The send port instance gets stuck at active state when you use BizTalk Server 2013

FIX: The send port instance gets stuck at active state when you use BizTalk Server 2013

View products that this article applies to.

Symptoms

Assume that you use MQSeries send port that contains EDI assembler component (like in EDISend pipeline) in Microsoft BizTalk Server 2013. When there's an invalid EDI message and the EDI validation fails, the send port instance doesn't suspend, it just gets stuck at active state and never goes away.

↑ Back to the top

Resolution

Cumulative update information

This issue was first fixed in the following cumulative update of BizTalk Server:

↑ Back to the top

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

↑ Back to the top

References

For information about the service packs and cumulative update list for BizTalk Server, see KB 2555976: Service pack and cumulative update list for BizTalk Server .

For more information about BizTalk Server hotfixes, see KB 2003907: Information about BizTalk hotfixes and cumulative update support .

↑ Back to the top

Keywords: kbqfe, kbfix, kbsurveynew, kbexpertiseadvanced, kb

↑ Back to the top

Article Info
Article ID : 2958349
Revision : 1
Created on : 1/7/2017
Published on : 10/9/2015
Exists online : False
Views : 402