Microsoft KB Archive Search

Notice: This website is an unofficial Microsoft Knowledge Base (hereinafter KB) archive and is intended to provide a reliable access to deleted content from Microsoft KB. All KB articles are owned by Microsoft Corporation. Read full disclaimer for more details.

  1. Home
  2. FIX: EDIFACT message is invalid when you use EDIFACT interchanges to send messages to partner in BizTalk Server

FIX: EDIFACT message is invalid when you use EDIFACT interchanges to send messages to partner in BizTalk Server

View products that this article applies to.

Symptoms

Assume that you are using EDIFACT interchanges to send messages to your partner in Microsoft BizTalk Server 2010 or 2013. You leave the UNB9 (Acknowledgment request) field in UNB Segment Definition Page (EDI Properties) of the Parties node in BizTalk Server Administrator Console as the default value.

Note The default value for the UNB9 (Acknowledgment request) field is 0 - ACK not required.

In this situation, you may receive an error message from your partner that says the EDIFACT message is invalid.

↑ Back to the top

Resolution

Cumulative update information

This issue was first fixed in the following cumulative update of BizTalk Server:

↑ Back to the top

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

↑ Back to the top

References

For information about the service packs and cumulative update list for BizTalk Server, see KB 2555976: Service pack and cumulative update list for BizTalk Server .

For more information about BizTalk Server hotfixes, see KB 2003907: Information about BizTalk hotfixes and Service Pack support .

↑ Back to the top

Keywords: kb, kbqfe, kbfix, kbsurveynew, kbexpertiseadvanced

↑ Back to the top

Article Info
Article ID : 2875914
Revision : 1
Created on : 1/7/2017
Published on : 10/10/2015
Exists online : False
Views : 419